Behavioural mixed-signal modelAM2302 moduledht22
DHT22 / AM2302 (temperature, humidity)
Temperature and humidity sensor with single-wire protocol (start pulse ≥ 1 ms, 40 bits with 26/70 µs pulses), module with 10 kΩ pull-up. New readings at most every 2 s. Values adjustable in the inspector, also during simulation. Drive with the Adafruit DHT library.
Key data
- Category
- Modules
- Simulation model
- Behavioural mixed-signal model
- Manufacturer part number
- AM2302 module
- Reference prefix
- U
- Pins
- 3
- Land pattern
- PinHeader_1x03_P2.54mm_Vertical
Simulation model
A behavioural model implements the interface of the chip (registers, protocol, timing) at its pins. The pins are connected to the analog circuit like CMOS pins.
- Model
- dht
- Supply pins
- VCC / GND
Pins 3
| Pin | Name | Use |
|---|---|---|
| VCC | VCCSupply pin | Supply 3.3–5 V |
| DATA | DATAI/O pin | Single-wire data: 10 kΩ pull-up (often on the module) |
| GND | GNDGround pin | Ground |
Parameters 2
Temperature
templiveDefault22 °C
Humidity
humliveDefault50 %
PCB
Connector / off-board
PinHeader_1x03_P2.54mm_VerticalDHT22 / AM2302 (temperature, humidity) as a module on a 3-pin header (VCC, DATA, GND) – compare the order with your own module